strang
12-22-2008, 11:58 AM
TOP SPEED FOR P220
lawn a Pulsar 220. My bike is not delivering top end speed and is stuck at
12okm/h not going beyond that. I have told the Probiking guys about this when I went for a fourth service. AftelYthat it has gone down to'II8kml h. My'bike's ado is at 7sookm. I also want to know if there is any problem if I use Nulon engine treatment oil in the bike. I don't want to use synthetic oil if there might be a problem using it after 1Ooookm.
110
Its difficult to say what is wrong by riding the bike. As the Pulsar 220 is a fuel injected bike, the question of the carburetor getting choked is out. Hence have the ECU uni checked. Also check the ignition timing, valve clearances
and compression pressures. Do not use Nulon additive as the clutch runs in the same engine oil and hence will tend to slip.
lawn a Pulsar 220. My bike is not delivering top end speed and is stuck at
12okm/h not going beyond that. I have told the Probiking guys about this when I went for a fourth service. AftelYthat it has gone down to'II8kml h. My'bike's ado is at 7sookm. I also want to know if there is any problem if I use Nulon engine treatment oil in the bike. I don't want to use synthetic oil if there might be a problem using it after 1Ooookm.
110
Its difficult to say what is wrong by riding the bike. As the Pulsar 220 is a fuel injected bike, the question of the carburetor getting choked is out. Hence have the ECU uni checked. Also check the ignition timing, valve clearances
and compression pressures. Do not use Nulon additive as the clutch runs in the same engine oil and hence will tend to slip.